What safety operation procedures are required for mechanical and electrical equipment installation projects?

Safety operating rules for electrical installation engineering of mechanical and electrical equipment

1, Electrical and mechanical equipment, small power tools, shall meet the requirements of this code and relevant standards, norms, and should be installed, dismantled and maintained by professional personnel.

2, the management of mechanical and electrical equipment should be "fixed people, fixed machines, fixed equipment", and personnel without professional qualifications are strictly prohibited from operating mechanical and electrical equipment. Before the use of small power tools, the user should carry out safety technology disclosure and safety technology operation procedures education.

3. Operators of mechanical and electrical equipment and small power tools must wear personal safety protective equipment according to regulations. The clothing of the mechanical operator should meet the safety requirements, tight and tight cuffs, no tie, and the plait of the female worker should be pulled into the working cap.

4. Before operating mechanical and electrical equipment and using small power tools, check the power cord and safety protection devices of mechanical and electrical equipment and small power tools. Electrical and mechanical equipment and small power tools with damaged power lines or safety protection device defects and failures shall not be put into use without professional replacement and repair. When the work is finished, the power supply should be cut off and the switch box should be locked. Small hand-held power tools should be handed over to the safekeeping room.

5, before the work must check the machinery, instruments, tools, etc., to confirm the good condition is allowed to use; Where trial operation is required, trial operation shall be carried out in accordance with regulations, and it can be put into use only after confirmation of normal operation

6, construction machinery and electrical equipment, small power tools shall not be "sick" operation and overload operation. If any abnormal situation is found in the operation, the machine should be stopped immediately for inspection. It is forbidden to scrub and repair the equipment when it is running. It is forbidden to extend the head and hand within the travel range of the machine during operation. Repair shall be carried out by professionals in accordance with the conditions specified in the original factory manual or relevant standards and specifications, and shall not arbitrarily use substitute parts or refit or transform.

7, the new machine, after overhaul or technical transformation of machinery, must be tested and test run according to the requirements of the factory manual and the current industry standard "construction machinery Technical Test Regulations" (JGJ 34).

8, the construction site mechanical and electrical equipment, small power tools must be in accordance with the factory specifications of the technical performance, bearing capacity, conditions of use and the relevant provisions of this code, correct operation, reasonable use, it is strictly prohibited to overload operation or arbitrary change, expand the scope of use. Instruments and related safety devices that need regular inspection and testing according to regulations shall be regularly inspected and tested by units with legal inspection and testing qualifications, otherwise they shall not be used.