Jiangsu Yiqi Electric introduction: Mechanical and electrical engineering installation process details?

Include the following aspects:

1. Equipment installation: Before equipment installation, check the basic acceptance and pay off the cables to ensure that the equipment is installed in an accurate position. When installing the device, pay attention to the levelness, verticality, and alignment of the device to ensure the smooth running of the device.

2. Pipe installation: Pipe prefabrication and cleaning should be carried out before pipe installation to ensure that the inside of the pipe is clean. During pipeline installation, attention should be paid to the slope of the pipeline, the spacing of the supports and the tightness of the pipeline connection to ensure the normal operation of the pipeline system.

3. Electrical installation: Cables should be laid and wired before electrical installation to ensure the normal operation of the electrical system. During electrical installation, pay attention to the laying method of cables, the handling of cable connectors, and the grounding of electrical equipment to ensure the safety of the electrical system.

4. Instrument installation: Instrument calibration and debugging should be carried out before instrument installation to ensure accurate measurement. When installing the instrument, pay attention to the installation position of the instrument, the sealing of the instrument connection and the protective measures of the instrument to ensure the normal operation of the instrument system.

5. Commissioning and acceptance: After the mechanical and electrical engineering installation is completed, the system should be debugging and acceptance to ensure the normal operation of the system. During commissioning and acceptance, attention should be paid to the function, performance and safety performance of the system to ensure that the system meets the design requirements.

The above are some aspects of the mechanical and electrical engineering installation process details, and the specific practices need to be adjusted and supplemented according to the specific situation of the project.