Share today: The process of assembling electrical control cabinet

The electrical control cabinet is a very important equipment in the construction of the power system, which mainly plays the role of power control and transmission, distribution and power transmission, and can be said to be the core part of the entire power system. Then the assembly process of the control cabinet is a very important link in the construction of the power system.

First, equipment inspection, painting, screen printing

When the various components of the equipment arrive at the assembly workshop, the assembly personnel need to take the drawings to check whether all the electrical control cabinets, electrical baseboards, electrical panels, button boxes, electrical accessories and other sizes are appropriate and whether the quality is qualified. Whether the size of the wire hole pre-set by the assembly of the control cabinet is appropriate, after the inspection is correct, the electrical assembly personnel need to carry out the process of painting and spraying, and the electrical panel needs to be printed by screen. Imitation Witto cabinet

2. Prepare all materials for the assembly of the control cabinet

In addition, before the assembly of the electrical control cabinet, we must first prepare all the materials for assembly, including various equipment, components and small accessories required for various assembly, etc., in addition, we need to prepare the tool kit, which is very important, including a screwdriver, pliers, drill, wrench and other assembly tools.

Third, install the electrical bottom plate

According to the layout of the bottom plate in the electrical drawing, measure the length of the groove and guide rail, and cut it with a saw bow. It should be noted that the groove should be placed on a flat place, the guide rail should be clipped to the bench vice saw, and the stitching should be smooth. After sawing, straighten it on the grinding wheel, use the electric drill to make fixed holes on the grooves and both ends of the guide rail. Lay out the cable slots and guide rails on the baseplate according to the design drawing, and mark their positions with a marker.